Using pfSense and an Alix. I have stacks of WRT54G series routers, and they are good, but often aren't up to the task. This limits their usage for things like streaming HD.
That said, I'd like to clarify some more my previous comments. For example, the discussion of NanoBSD - always having the default setting of read-only for the root file system.
An Embedded style installation is geared toward reduced writes on the filesystem, but also cannot run some of the more interesting available packages. A full install may be a little rougher on the target media, but is fully capable of using any packages and other features.
I keep hearing this repeated theme of "upgrade your hardware" in the forums ever since the introduction of the 2. I personally have not seen anything concrete as to why, so there's a huge gap between the understanding of embedded and "upgrade your hardware" I think for a lot of people.
I took a look at the 2. I observed that switching to read-write from read-only had no lag.
|pfSense help for a n00b | [H]ard|Forum||Linux - Networking This forum is for any issue related to networks or networking. Routing, network cards, OSI, etc.|
|Main Content||Come to find out there is a fix… ata0: Notes below… In the newer 2.|
There were no indications from top that memory or CPU were consumed, actually dead silent. So it's not clear at this point the technical problem but some quick looks around the internet about this problem with FreeBSD give some indication of a known problem.
Is there anything that the pfSense team can do to better understand this problem to maintain the intent of NanoBSD?
Or is NanoBSD dead?NanoBSD has been completely removed from pfSense , so an existing bit installation of pfSense using NanoBSD must be changed to a full installation. The best way to accomplish this task is by reinstalling pfSense on the firewall device, but in some cases that may be impossible or impractical.
I have also CCed this message to [email protected] to notify others currently using pfSense RC1 nanobsd version of the danger to flash memory.
Thanks. Bao -- Best Regards. PFSense – Service Not Available; / 2 Comments. Recently I attempted to log into a nanobsd pfsense firewall webGUI. Was not having any issues with the firewall other than not being able to access the webGUI.
you can navigate to “Diagnostics>NanoBSD>Media Read/Write Status” and tick the ‘keep media mounted read. pfSense is a free and open source firewall and router that also features unified threat management, load balancing, multi WAN, and more so the embedded version runs read only from flash, with read/write file systems as RAM disks.
The NanoBSD platform has two OS slices and a config slice. One OS slice is used to boot from, the other is used. May 04, · Just recently we removed the /cf read-write merge magic because we believed it can be replaced by simpler approaches (just don't write that much).
There's also extensive cleaning of system paths, unwinding soft-coded paths that are unlikely to change or won't change because the ports actually hardcode them, e.g. /var/run. Download the PFSense nanobsd Image image for the size of your CF memory card.
I downloaded the caninariojana.com to install on my 4 GB card.